Eddy Current NDT Pulsed Thermography for Enhanced Material Testing

NDT Eddy Current Techniques

Non-destructive testing (NDT), including eddy current testing and infrared thermography (IR), evaluates materials without causing damage. Eddy current testing induces magnetic currents to detect defects, while IR analyzes temperature variations. These techniques are vital in industries like aerospace and automotive.

Eddy current pulsed thermography ECPT

Active Infrared thermography, employing induction heating, is gaining prominence in non-destructive testing (NDT) for its reliability and precision in defect detection. Combining electromagnetic excitation and transient infrared thermography, this method heats samples with induced eddy currents and detects defects through thermal distribution disturbances captured by an IR camera. This technique offers wide applicability, high detection speed, and contactless inspection. This application note assesses the effectiveness of Electromagnetic-thermal NDT through Finite Element Method (FEM) analysis. The model comprises a spiral coil around a U-shaped ferrite core inspecting a defective structural steel workpiece. See Figure 1 for a schematic of the ECPT technique and the 3D design under study.

Problem Description

Utilizing the AC magnetic module of EMS coupled with the transient thermal solver, this analysis aims to compute and visualize the distribution of eddy currents and temperature around a specimen crack. A ferromagnetic core is employed to concentrate flux around the defect, ensuring uniform induction heating and facilitating open-view IR imaging for quantitative evaluation of cracks.

The figure below depicts the semi-elliptical crack shape, while Table 1 provides detailed dimensions of each component.

Part	Material	Density (kg/)	Magnetic permeability	Electrical conductivity    (S/m)	Thermal conductivity (W/m.K)	Specific heat capacity (J/Kg.K)
Coil	Copper (Cu)	8900	0.99	6 E+07	385	390
Specimen	Structural steel	7800	200	4.032 E+6	44.5	475
Yoke	Ferrite	4900	2300	0.15	Not Required

Boundary conditions 

1-Electromagnetic input 

The copper inductor is modeled as a solid coil within the simulation. It supports a current input ranging from 55 A RMS with a frequency of 155 kHz.

2-Thermal input

Thermal convection is applied to the air surrounding the model, with an ambient temperature of 20°C. The heat transfer coefficient is set to 5 W/m²°C.

Mesh

A fine mesh was applied to the top surface of the specimen and to the crack using EMS's mesh control feature. This ensures accurate representation of the localized eddy currents across the skin depth of the tested plate.

Results

After 500 ms of induction heating, the simulation revealed significant findings. The current density distribution around the crack on the specimen surface displayed a clear perturbation of eddy currents, reaching maximum intensity around the endpoints of the detected defect. The altered flow directions of currents induced by the crack resulted in uneven heating of the surface.

Figure 4 - Vector plot of current density distribution
 

The induced temperature distribution is depicted in Figure 5. Across the central region of the U-shaped core on the specimen, the temperature appears to be evenly distributed. The maximum temperature is observed at the contours of the crack, reaching 23.13 °C, aligning well with the results reported in Reference [1].

Figure 6 illustrates the region of heated air delimited by the crack. Noticeably, the temperature at the endpoints of the defect surpasses that of other areas, sharply declining in the depth direction. These distinct characteristics aid in predicting the crack length from the two peak temperature points at the edges and determining the temperature difference between the crack and other regions.

Conclusion

References

[1]- He, Min, Laibin Zhang, Wenpei Zheng, and Yijing Feng. "Investigation on a new inducer of pulsed eddy current thermography." AIP Advances 6, no. 9 (2016): 095221.